Implementation of harmonics reduction filters in non-linear equipment at plastic manufacturing company

Authors

  • Muhammad fadlan siregar Universitas Medan Area
  • Muhammad Ikhwan Fahmi Department of Electrical and Engineering, Faculty of Technology, Universitas Prima Indonesia, Indonesia
  • Syofyan Anwar Syahputra Department of Electrical and Engineering, Akademi Teknik Deli Serdang, Indonesia
  • Habib Satria Department of Electrical Engineering, Faculty of Technology, Universitas Medan Area, Indonesia
  • Indri Dayana Department of Electrical Engineering, Faculty of Technology, Universitas Medan Area, Indonesia
  • Moranain Mungkin Department of Electrical Engineering, Faculty of Technology, Universitas Medan Area, Indonesia

Keywords:

frequency fundamental, , Harmonic Spectrum, , Single Tuned Filter, , IEEE standard, , power quality analyzer

Abstract

Harmonics are produced by non-linear loads such as televisions, computers, microwaves, fluorescent lamps that use electronic ballasts and others. The harmonic content contained in non-linear loads causes the quality of electrical power to become poor and the quality of electrical power to decrease, the greater the use of non-linear loads, it is estimated that the harmonics generated will be greater and can disrupt the system performance of other electronic equipment and can also cause overheating of electrical power sources, plastic manufacturing company measurements, Source Voltage Balanced (V peak) Unbalanced (V peak) 312∠ 00, 311∠ -1200, 312∠ 1200, Phase R 3.23 Ampere, Phase S 3.24 Ampere Phase T 3, 24 Amperes as in figure 2a, and THD Current in Phase R 25%, Phase S 23% Ampere Phase T 24%, the total harmonic distortion was above 5% and the analysis for the single tuned filter was C value > 50.64 μF, L value > 10.093 H, and R value > 50.98 Ω. then after, harmonic values, a filter was installed to reduce the THD value to 1.4% and the overall THD value was below 5% in accordance with IEEE standards.

References

[1] Mohamed S. Seddik, Magdy B. Eteiba and Jehan Shazly Evaluating the Harmonic Effects on the Thermal Performance of a Power Transformer: Energies, : 17, (4871), 2024, 2 of 17 https://doi.org/10.3390/en17194871.

[2] Wilfredo Urbina – Romero, Gaussing Harmonic Analysis Springer monografhs in mathematics, 2019, https://www.springer.com/series/3733.

[3] Shareghi, M.; Phung, B.T.; Naderi, M.S.; Blackburn, et al. Effects of Current and Voltage Harmonics on Distribution Transformer Losses. In Proceedings of the 2012 IEEE International Conference on Condition Monitoring and Diagnosis, Bali, Indonesia, 23–27 September 2012. https://doi.org/10.1109/CMD20148.2012

[4] J. C. Das, Marcel Dekker, Inc, Power System Analysis - Short-Circuit Load Flow and Harmonics, 2002.

[5] Tamer M. Z. Elsharkawy, Gomaa F. A. Osman & Waleed A. A. Salem, The effect of nonlinear loads on the underground distribution cables: a case study, Journal of Electrical Systems and Information Technology: 9 (19), 10 October 2022 https://doi.org/10.1186/s43067-022-00061-2.

[6] Michael McCarty, Taufik Taufik, Andre Pratama, Makbul Anwari, Harmonic Analysis of Input Current of Single Phase Controlled Bridge Rectifier, Symposium on Industrial Electronics and Applications (ISIEA 2009), October 4-6, 2009, Kuala Lumpur, Malaysia, https://DOI.org/10.1109/ISIEA.2009.5356404

[7] Wakileh G.J, Power System Harmonics: Fundamental, Analysis and Filter Design, Springer Velag Press, 2001, https://link.springer.com/book/10.1007/978-3-662-04343-1.

[8] James M. Fiore, Semiconductor Devices - Theory and Application, https://LibreTexts.org

[9] Dugan, Roger C. Mc Granaghan et.al. Electrical Power System Quality. Second edition, McGraw Hill. pp 167-294, 2004. https://gcebargur.ac.in/sites/gcebargur.ac.in/files/lectures_desk/electrical_power_systems_quality.pdf

[10] Ying-Tung Hsiao, Design of Filters for Reducing Harmonic Distortion and Correcting Power Factor in Industrial Distribution Systems, Journal of Applied Science and Engineering, 4. (3) 2001, https://doi.org/10.6180/jase.2001.4.3.06

[11] A. Priyadharshini, N. Devarajan, A.R Saranya, R. Anitt, Survey of Harmonics in Non-Linier Loads. International Journal of Recent Technology and Engineering [IJRTE]. ISSN. 2277 – 3878. 1:1 April, 2012. DOI: https://doi.org/10.35940/ijrte.2277-3878

[12] Mehmet Cinar, Effects of Harmonics in Electric Power Systems and Solution Methods, Journal International Journal of Innovations in Engineering Research and Technology, 2019 : 6(12) ISSN. 2394-3696

[13] G.Suresh Babu, U.K.Choudhury, G.Tulasi Ramdas, a Novel Approach In the Design of Optimal Tuning Frequency of a Single Tuned Harmonic Filter for an Alternator with Rectifier Loads, Journal of Theoretical and Applied Information Technology, 2010 https://jatit.org

Downloads

Published

2018-12-31

Issue

Vol. 2 (2024): Proceedings of International Conference on Multidisciplinary Engineering (ICOMDEN)

Section

Articles

License

Copyright (c) 2024 Muhammad fadlan siregar, Muhammad Ikhwan Fahmi, Syofyan Anwar Syahputra, Habib Satria, Indri Dayana, Moranain Mungkin

Creative Commons License

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

Copyright Notice

Authors published in this journal agree to the following terms:
1. The copyright of each article is retained by the author (s).
2. The author grants the journal the first publication rights with the work simultaneously licensed under the Creative Commons Attribution License, allowing others to share the work with an acknowledgment of authorship and the initial publication in this journal.
3. Authors may enter into separate additional contractual agreements for the non-exclusive distribution of published journal versions of the work (for example, posting them to institutional repositories or publishing them in a book), with acknowledgment of their initial publication in this journal.
4. Authors are permitted and encouraged to post their work online (For example in the Institutional Repository or on their website) before and during the submission process, as this can lead to productive exchanges, as well as earlier and larger citations of published work.
5. Articles and all related material published are distributed under a Creative Commons Attribution-ShareAlike 4.0 International License.